SP-79-2011
View Larger Image

SP-79-2011

Socket Welding Reducer Inserts

PURPOSE
To provide a Standard Practice establishing requirements for insert type fittings, which effectively, after welded installation, creates a socket welded reduced end fitting, such as a Tee, 90-degree Ell, Cross, 45-degree Ell, Coupling, etc.
SCOPE
General This Standard Practice covers ratings, dimensions, tolerances, finish, marking and material requirements for socket welding reducer inserts for use with ASME B16.11, Class 3000 and 6000 socket welding fittings. U.S. customary unit dimensions for these reducer inserts are shown in Table 3 and (SI) metric dimensions are shown in Table 3M.
Fitting Sizes/Pipe Correlation Fittings covered by this Standard Practice are shown in Table 1, by class, size range and correlation to the schedule number or wall designation of pipe for calculation of ratings.
Partial Compliance Fittings Fittings with special dimensions and fittings made from non-standard materials may be designed and manufactured by agreement between the manufacturer and the purchaser, provided they are marked in accordance with the requirements for partial compliance fittings of Section 5.1.1(e).
Welding Except for the CAUTIONARY NOTE (see Section 12) and the GAP RECOMMENDATIONS (see Figures 1 and 2), installation welding requirements are not within the scope of this Standard Practice. Installation welding shall be done in accordance with the applicable piping system into which the fittings are to be installed.

     


Today is Sunday
April 21, 2019

MSS Member Login

MSS Scholarships

MSS Apparel

We Accept:
VISA  MasterCard  American Express
Discover  Diners Club 
Site Secured by:

Like us on:

Accept Credit Cards Online